This is a working overview of Selank, written for readers who want more than a one-paragraph summary but less than a textbook.
This page was last updated on 2025-08-13 and is reviewed periodically as new material appears.
Reversed-phase high-performance liquid chromatography is the standard technique for estimating peptide purity. The result is a peak-area percentage, which describes how much of the detected material elutes as the main peak in one run. Mass spectrometry confirms the molecular mass and can reveal truncated, adducted, or otherwise modified species. Amino acid analysis or tandem mass spectrometry can address sequence fidelity when identity is in doubt. None of these measurements, taken alone, establishes that a sample is fit for any specific purpose.
Lyophilized selank is normally supplied as a dry powder and is considered stable for extended periods when kept cold and dry. Moisture uptake is the main practical threat, because absorbed water promotes both hydrolysis and aggregation in the solid state. Vials are usually warmed to room temperature before opening so that condensation does not form on the powder. Supplier documentation commonly specifies -20 °C for routine storage, with -80 °C used for material intended to be archived for years.
Once dissolved, the peptide is markedly less stable than the dry powder. Aqueous solutions are subject to backbone hydrolysis and to microbial growth when they are handled without sterile technique. Buffered solutions near neutral pH are common for short-term laboratory work, while acidic conditions are sometimes used to improve solubility. Analytical laboratories generally prepare working solutions fresh rather than storing them, and a residual water film left in a reopened vial can seed degradation even when the container appears dry.
Peptide bonds in selank are susceptible to hydrolysis under strongly acidic or basic conditions, and the terminal proline residues are vulnerable to exopeptidase activity in biological samples. Lyophilized powder stored dry at -20 °C typically remains stable for extended periods, whereas aqueous solutions degrade faster and may lose measurable purity within days to weeks depending on pH, temperature, and microbial load. Repeated freeze-thaw cycles promote aggregation and adsorption to container surfaces. For analytical work, solutions are usually prepared fresh, kept cold, and used within a single working day.
Handling follows standard practice for research peptides. Material is weighed in a low-humidity environment because the powder absorbs atmospheric moisture. Purity is reported as the percentage area of the main peak in a chromatogram, with specifications commonly set at 95 percent or higher; values below that threshold indicate the presence of truncated or modified species. Residual trifluoroacetate from purification is often present and may affect mass balance. Certificates of analysis should state the analytical method, the column and gradient used, and the lot-specific retention time so that results can be compared across suppliers.
| Property | Value | Notes |
|---|---|---|
| Typical purity specification | 95 percent or higher by RP-HPLC | Area percentage of the main peak |
| Identity confirmation | Electrospray ionization mass spectrometry | Observed mass compared with the theoretical value near 751.9 Da |
| Recommended dry storage | -20 °C, desiccated | -80 °C for multi-year archival material |
| Solution handling | Prepare fresh; avoid long storage | Sterile filtration reduces microbial load |
| Common synonyms | TKPRPGP; TP-7 | Sequence code and laboratory designation used interchangeably |
Selank is a synthetic heptapeptide with the sequence Thr-Lys-Pro-Arg-Pro-Gly-Pro. Its four N-terminal residues reproduce tuftsin, a tetrapeptide fragment of the immunoglobulin heavy chain, while the C-terminal Pro-Gly-Pro extension is a synthetic addition. The peptide has a molecular mass near 752 daltons and carries a net positive charge at physiological pH because of the arginine and lysine side chains. Published indexes list it under the name Selank and the sequence abbreviation TKPRPGP. Solid-phase peptide synthesis is the standard production route for research quantities.
Development took place at the Institute of Molecular Genetics of the Russian Academy of Sciences, where a series of short peptides were designed in the 1980s and 1990s. Selank was selected from variants of tuftsin that showed resistance to plasma peptidases. Russian regulatory approval covers it as an anxiolytic agent given intranasally. Outside that market the compound is normally handled as a research chemical rather than a medicine, and no widely recognised international pharmacopoeial monograph exists. The name Selank is a coined trade designation rather than a systematic chemical name.
Lyophilized material is generally stable for extended periods when kept dry at or below minus twenty degrees Celsius. Working solutions are less stable, and common practice is to aliquot and freeze them so that repeated freeze-thaw cycles are avoided. Aqueous solutions are sensitive to pH extremes and to microbial growth, so short-term storage at refrigerator temperature is typical. Oxidation and hydrolysis are the principal degradation routes. Reconstitution with sterile water or a mild buffer is standard, and solutions should be protected from light.
Regulatory treatment varies by jurisdiction. In Russia the compound is a registered prescription product, while in the European Union and the United States it is generally handled as a research chemical without a marketing authorization. Suppliers therefore operate outside pharmaceutical oversight, and buyers rely on supplier documentation for purity and identity claims. Chain of custody and third-party testing are the main verification tools. Analysts note that the absence of a pharmacopoeial monograph for research-grade material limits standardization across vendors.
Purity assessment relies mainly on reverse-phase high-performance liquid chromatography with ultraviolet detection. Because the peptide lacks a strong chromophore, detection often uses backbone absorbance near 214 nm. Identity is confirmed by mass spectrometry, typically electrospray ionization or matrix-assisted laser desorption, comparing the measured mass against the expected value. Amino acid analysis can verify composition after acid hydrolysis. Diastereomer content and residual counterions are reported less often, although both can influence biological assays.
=== Birth of international drug networks (1995–2006) === During the 1990s, many drug kingpins in South America preferred to operate their smuggling businesses through West African countries, like Ghana and Senegal, due to the absence of customs controls in the most important ports of these countries. Over time, South American cartels have created trafficking routes through North Africa for export to Europe. Morocco has an important strategic geographical placement and also a large diaspora in the most important countries of Europe, which is what eventually has set them apart from other countries on the African continent. While in Morocco the Rif mountains and port cities, like Tangier or Tétouan, were often counted on for the production and trafficking of drugs, in Europe, Antwerp became the European trafficking hub alongside Spain. With Antwerp and its Port, the whole of Belgium also became a geographic hub for drug export. Importation of goods and drug trafficking became inseparable over time, and these activities compensated for the layoffs that affected miners, steelworkers and textile workers on a massive scale. In this context, the old manners, habits, and the traditional codes of conduct, honor, justice, and distrust in authority were transplanted in the districts of Brussels, Amsterdam, and Antwerp, where these communities were able to grow significantly, notably with the establishment of a friendly relationship with the Dutch Penose, at that time amongst some of the largest criminal organisations in Europe.
== Selected publications == Robinson, Arthur B.; McKerrow, James H.; Cary, Paul (1970). "Controlled Deamidation of Peptides and Proteins: An Experimental Hazard and a Possible Biological Timer". PNAS. 66 (3): 753–757. Bibcode:1970PNAS...66..753R. doi:10.1073/pnas.66.3.753. PMC 283114. PMID 5269237. Pauling, Linus; Robinson, Arthur B.; Teranishi, Roy; Cary, Paul (1971). "Quantitative Analysis of Urine Vapor and Breath by Gas-Liquid Partition Chromatography". PNAS. 68 (10): 2374–2376. Bibcode:1971PNAS...68.2374P. doi:10.1073/pnas.68.10.2374. PMC 426616. PMID 5289873. Robinson, Arthur B.; Robinson, Laurelee R. (1991). "Distribution of glutamine and asparagine residues and their near neighbors in peptides and proteins". PNAS. 88 (20): 8880–8884. Bibcode:1991PNAS...88.8880R. doi:10.1073/pnas.88.20.8880. PMC 52614. PMID 1924347. Soon, Willie H.; Baliunas, Sallie L.; Robinson, Arthur B.; Robinson, Zachary W. (1999). "Environmental effects of increased atmospheric carbon dioxide". Climate Research. 13 (2): 149–164. Bibcode:1999ClRes..13..149S. doi:10.3354/cr013149. Robinson, Noah E.; Robinson, Arthur B. (2001). "Molecular clocks". PNAS. 98 (3): 944–949. Bibcode:2001PNAS...98..944R. doi:10.1073/pnas.98.3.944. PMC 14689. PMID 11158575. Robinson, Arthur B.; Robinson, Noah E. (2008). "Use of Merrifield solid phase peptide synthesis in investigations of biological deamidation of peptides and proteins". Peptide Science. 90 (3): 297–306. doi:10.1002/bip.20852. PMID 17896348. S2CID 35618789.
==== United States ==== In the United States, codeine is regulated by the Controlled Substances Act. Federal law dictates that codeine be a Schedule II controlled substance when used in products for pain relief that contain codeine alone or more than 80 mg per dosage unit. Codeine without aspirin or acetaminophen (Tylenol) is very rarely available or prescribed to discourage abuse. Tablets of codeine in combination with aspirin or acetaminophen (paracetamol) and intended for pain relief are listed as Schedule III. Cough syrups are classed as Schedule III, IV, or V, depending on formulation. For example, the acetaminophen/codeine antitussive liquid is a Schedule IV controlled substance. Some states have chosen to reclassify codeine preparations at a more restrictive schedule to lower the instances of its abuse. Minnesota, for instance, has chosen to reclassify Schedule V some codeine preparations (e.g. Cheratussin) as a Schedule III controlled substance.
MVA-BN (brand names: Imvanex, Imvamune, and Jynneos) is a modified vaccinia Ankara (MVA) vaccine manufactured by Bavarian Nordic by growing MVA in cell culture. Unlike replicating vaccines, MVA-BN is administered by injection via the subcutaneous route and does not result in a vaccine "take." A "take" or "major cutaneous reaction" is a pustular lesion or an area of definite induration or congestion surrounding a central lesion, which can be a scab or an ulcer. MVA-BN can also be administered intradermally to increase the number of available doses. It is safer for immunocompromised patients and those who are at risk from a vaccinia infection. MVA-BN has been approved in the European Union, Canada, and the United States. Clinical trials have found that MVA-BN is safer and just as immunogenic as ACAM2000. This vaccine has also been approved for use against mpox. It received WHO prequalification against smallpox and Mpox in September 2024.
Sources: en.wikipedia.org
Plants can synthesise coloured dyes and pigments such as the anthocyanins responsible for the red colour of red wine, yellow weld and blue woad used together to produce Lincoln green, indoxyl, source of the blue dye indigo traditionally used to dye denim and the artist's pigments gamboge and rose madder. Sugar, starch, cotton, linen, hemp, some types of rope, wood and particle boards, papyrus and paper, vegetable oils, wax, and natural rubber are examples of commercially important materials made from plant tissues or their secondary products. Charcoal, a pure form of carbon made by pyrolysis of wood, has a long history as a metal-smelting fuel, as a filter material and adsorbent and as an artist's material and is one of the three ingredients of gunpowder. Cellulose, the world's most abundant organic polymer, can be converted into energy, fuels, materials and chemical feedstock. Products made from cellulose include rayon and cellophane, wallpaper paste, biobutanol and gun cotton. Sugarcane, rapeseed and soy are some of the plants with a highly fermentable sugar or oil content that are used as sources of biofuels, important alternatives to fossil fuels, such as biodiesel. Sweetgrass was used by Native Americans to ward off bugs like mosquitoes. These bug repelling properties of sweetgrass were later found by the American Chemical Society in the molecules phytol and coumarin.
== Bibliography == Bonagura J., DVM; et al. (2000). Current Veterinary Therapy. Vol. 13. pp. 321–381. Cossar, Harper (2011). Letterboxed: The Evolution of Widescreen Cinema. University Press of Kentucky. ISBN 978-0-813-12651-7. Halliwell, Martin (2013). Therapeutic Revolutions: Medicine, Psychiatry, and American Culture, 1945-1970. Rutgers University Press. ISBN 978-0-813-56066-3. Ingle DJ (October 1950). "The biologic properties of cortisone: a review". J. Clin. Endocrinol. Metab. 10 (10): 1312–54. doi:10.1210/jcem-10-10-1312. PMID 14794756. Woodward R. B.; Sondheimer F.; Taub D. (1951). "The Total Synthesis of Cortisone". Journal of the American Chemical Society. 73 (8): 4057. Bibcode:1951JAChS..73.4057W. doi:10.1021/ja01152a551.
== Computer-aided drug design == The most fundamental goal in drug design is to predict whether a given molecule will bind to a target and if so how strongly. Molecular mechanics or molecular dynamics is most often used to estimate the strength of the intermolecular interaction between the small molecule and its biological target. These methods are also used to predict the conformation of the small molecule and to model conformational changes in the target that may occur when the small molecule binds to it. Semi-empirical, ab initio quantum chemistry methods, or density functional theory are often used to provide optimized parameters for the molecular mechanics calculations and also provide an estimate of the electronic properties (electrostatic potential, polarizability, etc.) of the drug candidate that will influence binding affinity. Molecular mechanics methods may also be used to provide semi-quantitative prediction of the binding affinity. Also, knowledge-based scoring function may be used to provide binding affinity estimates. These methods use linear regression, machine learning, neural nets or other statistical techniques to derive predictive binding affinity equations by fitting experimental affinities to computationally derived interaction energies between the small molecule and the target. Ideally, the computational method will be able to predict affinity before a compound is synthesized and hence in theory only one compound needs to be synthesized, saving enormous time and cost.
Sources: en.wikipedia.org
Sealed, desiccated storage at -20 °C or colder is the standard recommendation for research-grade material. Vials should reach room temperature before they are opened, which limits condensation. Repeated temperature cycling is discouraged.
A reported purity value reflects the share of the main peak in one chromatographic run and says nothing about identity. Confirming that the expected sequence is present requires a separate measurement such as mass spectrometry. Purity and identity are distinct questions.
A mass spectrum reports the molecular masses present in a sample and shows whether they match the value expected for selank, near 751.9 Da. It also flags common artifacts such as truncation or adduct formation. It does not establish correct stereochemistry or complete sequence order on its own.
Identity is confirmed by matching the retention time in reversed-phase chromatography against a reference standard and by measuring the molecular mass with mass spectrometry. Tandem mass spectrometry or amino acid analysis can verify the sequence of the seven residues. Because the peptide contains no aromatic amino acids, detection at 280 nm is not useful.